The DynaGen™ TG410 is a generator controller that supports three-phase voltage metering for generator applications. It provides autostart operations for mechanically or electronically governed engines and has a Modbus port with galvanic isolation to connect remote annunciators and internet monitoring devices. It is ideally suited for mobile or stationary equipment where reliability is critical.
- Three-phase volt metering
- Modbus port with galvanic isolation
- Tier 4F and Euro Stage V compliant
- Supported by RapidCore™ configurator software
- Complete plug-n-play package option
- Private label option
- Five-year or 17,500-hour warranty
-
Datasheets
-
User Manuals
-
Wiring Schematics
-
Accessory Sheets
-
Solution Cards
-
Compliance Docs
-
Firmware
Rugged Housing
Conformally coats for protection against moisture and contaminants. Front panel gasket for panel water ingress protection
Display
Oil pressure, engine temperature, fuel and oil levels, hour meter, RPM, battery voltage, real time clock with date/time, J1939 DTC codes, DPF and DEF status icons, J1939 percent load and percent torque, custom screens for pumping or compressor applications and power factor, apparent power, real power and reactive power metering for generator applications
Autostart
Autostart on low battery, automatic shutdown and warnings, manual and remote start, and autostart trigger on sensor value (pressure, temperature, level voltage)
Functions
Built-in weekly scheduler, maintenance counter, preheat and many configurable timers, stall detection, retry on false start, custom warnings and failures, Configurable Diagnostic Trouble Code (DTC), load imbalance detection and IDMT overcurrent protection, exercise clock and 150 event logs
Speed Control
Speed control offset adjustment for electronic engines, RPM via J1939, magnetic pick-up or generator and configurable setpoint RPM output feature
Closed Loop Control
Closed loop control on custom senders
Senders
Accepts common senders (VDO, Datcon, Murphy and more)
Modbus Communication
RTU slave mode, RS485 port (9600, 19200, 38400, 57600 baud)
Switch Inputs
Single or dual float switch input control
Engine Support
Supports mechanical or CANbus J1939 engines
Warranty
Five-year warranty or 17,500 hours
ISO Certification
Manufactured in an ISO 9001:2015 certified operation
RelayPak
Snap on RelayPak eliminates the need to mount and wire external slave relays for fuel crank and up to two other loads
Monitoring
RemoteIQ remote monitoring and control available with cellular modem
Heater LCD
Heated LCD version available for operation and display down to -40 C
Mimic Panel
TR100 is available for TG350 and TG410 controllers and mimics what is displayed on the controller.